Winterizing your Above Ground Pool

Your pool can be easily emptied and stored in a safe place during the winter. However, many people choose to leave their pool up year round. In areas where freezing temperatures occur, there is risk of ice damage. It is recommended to drain, disassemble and store the pool in a safe place when temperatures drop below 32 degrees Fahrenheit. See "How To Drain Your Pool" section. Clean pool water thoroughly (If Easy Set Pool make sure the top ring is properly inflated). Remove the skimmer (if applicable) or any accessories attached to the threaded strainer connector. Replace strainer grid if necessary. Be sure all accessories parts are clean and completely dry before storage. Plug the Inlet and Outlet fitting from the inside of the pool with the plug provided (sizes 10' and 12'). Close the Inlet and Outlet Plunger Valve (15', 18', and 24'). Remove the ladder (if applicable) and store in a safe place. Be sure the ladder is completely dry before storage. Remove the hoses that connect the pump and filter to the pool. Add appropriate winter chemicals. Consult your local pool dealer as different regions vary greatly. Cover pool with Intex Pool Cover. IMPORTANT: INTEX POOL COVER IS NOT A SAFETY COVER. Clean and drain pump, filter housing and hoses. Remove and discard old filter cartridge (keep a spare cartridge available for next season). Bring pump and filter parts indoors and store in a safe and dry area, preferably heated. STORING POOL FOR WINTER After draining pool, dry pool liner completely (100%). Sprinkle talcum powder on liner to prevent vinyl from sticking together and to absorb any water you may have missed. Roll pool liner to avoid creases and relocate to storage area. Place it in original carton if you saved it. Keep all small parts together with filter pump, manual, and pool, and then place in an area that will remain at room temperature throughout the storage season.